| ArcTrak
Plus™ |
Micro
ADM STATISTICAL ANALYSIS PROGRAM |
The
ArcTrak Plus™ program provides a GUI for the Computer
Weld Technology Inc. Micro ADM™ sensor using the ModBus RTU
protocol. The Program allows the user to collect; graph and display
weld
data in a real time mode. The program provides a simple interface
to configure the Micro ADM™ sensor parameter. The Micro ADM™ sensor
is designed to provide the end user with a simple and cost effective,
in-process weld monitoring system.
|
| |
| The sensor provides fault testing of the basic welding
parameters (i.e. Volts, Amps, Wire Speed, Gas Pressure and Arc Time).
It incorporates an advanced testing algorithm that provides three
levels of fault testing. The sensor provides in-process parameter
limit testing, Arc Density (AAD) for each weld in a Part and an ADD,
Weld Count and Volume Applied test for each Part.
The sensor also features a Part Learn Mode that allows the sensor
to establish statistical control limits based on actual production
parts. The ArcTrak Plus™ program allows the user to upload
run time weld data and stored SPC weld summary data.
It also allows the user to graphically analyze the stored data
and to view the internal sensor parameters and configure the basic
sensor parameters.
|
| |
|
|
| FEATURES |
- "Pull-down"menu
screens
- Tool
Bar "Speed Buttons"
- Control
Bar "Command Buttons"
- Real
time on screen sweep graphs, displayed simultaneously, for
up to four user definable parameters
- Graph
"Zoom" capability during data collection or data
review phase
- Graphical
and statistical analysis of stored weld data
- Calculate,
display, edit and store Arc Data Monitor limits
|
|
| SYSTEM
REQUIREMENTS |
- 150mhz
Pentium™ or higher microprocessor
- Windows® 98/ME
or Windows 2000/XP® platforms
- 24
Megs minimum for Windows® 98/ME, 32 Megs for Windows
2000/XP®
- 25
Megs of available hard drive space
- Minimum
SVGA graphics, XVGA recommended
- RS-232
serial port
|
|
| |
| |
|
